Transcend
odtwarzacz mp3
T sonic 840
Transcend T sonic 840 Instrukcja
Oto Transcend T sonic 840 (odtwarzacz mp3) instrukcja użytkownika. 73 strony w języku English o wadze 4.7 Mb. Jeśli nie możesz znaleźć odpowiedzi na swoje pytanie Zapytaj naszą społeczność.
Strona 1/73
Read and understand the manual for use of this
accessory with the tool.
This accessory is for 90 degree cuts only.
1. Remove plug from power source, and remove the blade guard
assembly.
2. Lower the blade completely below the table surface.
3. Lay insert in the table opening as shown in figure 1, and secure in
place with the four mounting screws provided.
4. Turn saw on and slowly raise blade as high as it will go until blade
cuts completely through the insert to rear slot opening.
5. Reattach the blade guard assembly.
The table insert should be adjusted so it is flush with the saw table
surface (Fig. 2).
The GTS1031 table insert slot includes four (4) adjustment screws to
set the height (Fig. 3). Place the insert onto the table. Place a straight
edge (such as the metal ruler from a combination square) across the
table top and insert top – the surfaces should be at the same level
(Fig. 2). If adjustment is necessary, use the included 2 mm “L wrench”
(packed with GTS1031) to rotate each set screw up or down.
Never operate the saw without the proper insert in place. Use the
saw insert when sawing and the dado insert when da doing.
!
WARNING
LEVELING SCREWS
VIS DE MISE À NIVEAU
TORNILLOS NIVELADORES
LEVELING SCREWS
VIS DE MISE À NIVEAU
TORNILLOS NIVELADORES
FIG. 3
FIG. 1
FIG. 2
TABLE INSERT
ÉLÉMENT
AMOVIBLE
INSERCIÓN DE
LA MESA
MOUNTING
SCREWS
VIS DE MONTAGE
TORNILLOS DE
MONTAJE
MOUNTING
SCREWS
VIS DE MONTAGE
TORNILLOS DE
MONTAJE
BM 2610015698 12-10:BM 2610998789 11/10.qxp 12/17/10 10:46 AM Page 1
Rozwiązywanie problemów Transcend T sonic 840
Jeśli dokładnie przeczytałeś instrukcję, ale nie znalazłeś rozwiązania swojego problemu, poproś o pomoc innych użytkowników
Specyfikacje
| Marka: | Transcend |
| Kategoria: | odtwarzacz mp3 |
| Model: | T sonic 840 |